TEST EQUIPMENT

  • 产品名称: Circular Saw Lower Guard Test Device
  • NO.: HDD8302
  • Views : 4

 IEC 60745-2-5 : Particular requirements for circular saws, clause 19.102.3 and Annex BB, EN 60745-2-5.

 This device is applicable to test the closing time and mechanical strength of lower guard for circular saws. 

 Circular saws 

 

 The saw is to be set for a 90°cut and oriented in the horizontal plane. The lower guard is to be cycled from the full closed position to the maximum open working position and then released for 50000 cycles at a rate not less than 10 cycles per minute. The cycle numbers recorded by a position sensor. Following the cycle, the closure time shall not exceed 0.3s. The device record the times when detected closure time exceed 0.3s. When preset test times completed, device record the last closure time and stop automatically. 

 

No.

Item

Specification Remark

1

Power supply

220V/50HZ  

2

Electrical control

     MITSUBISHI PLC operation, 

    7 Inch Touch screen operation
 

3

Drive

Motor  
4 Test times 0-999999 times, preset  
5 Detection time 0~9.99s,display Closure time
6 Automatic / manual speed 0-30 times / min, can be prese  
7 Manual state rotation
Touch control,
clockwise or counter clockwise
 
8 Dimension 80*70*100cm, about 80kg  

 

CONSULTATION

 
Title:
 
Your name:
*
Less than or equal to 20 characters (including AZ, az ,0-9, Chinese characters, excluding special characters)
Your E-mail:
*
Example:example@mail.com
Tel:
 
Less than or equal to 32 characters (including 0-9, -, (,), comma)
Content:
* Entered characters:0 Word
Less than or equal500Character
Verification code:
   
GUANGZHOU HONGCE EQUIPMENT CO., LTD
FOLLOW US