Test Probe a
Standard: IEC 60745-2-5 : Particular requirements for circular saws, clause 19.101.2 and Figure 105
Application: This probe is applicable to verify the upper guard protection against to touch the blade.
Test sample: Circular saws
Feature: Apertures in the guarding system above the guide plate, unless otherwise specified below, shall be designed such that the test probe ‘a’ of figure 105, when inserted at any angle and to the depth allowed by its stop, shall not be able to contact the cutting edge zone of any recommended blade.
- Probe: diameter 12mm, length 50mm, R6 hemisphere end
- Stop: diameter 35mm, thickness 5mm
- Handle: diameter 8mm, length 30mm